Made4Trade End Feed Half Crossover
End feed capillary fitting is part of the Made4trade range and manufactured to BS EN 1254-1. This fitting joints copper tube manufactured to BS EN 1057 using solder.
It is suitable for above ground hot and cold domestic or potable water services, central heating systems, low-pressure steam heating and pressurised unvented heating systems. It is equally suitable for sanitation services and compressed air lines, gas distribution systems for natural and manufactured gases.
A solder joint is created through the principal of capillary action, when the fitting and tube is assembled and heated to the appropriate temperature, solder becomes molten and is drawn into the gap between tube and fitting for a durably reliable joint. It is recommended soldering flux is also used to aid in this.
Available in 15 & 22mm sizes.
Manufactured from copper
For use on hot and cold water systems
Neat, tidy installation when installed by an experienced fitter
System covers all aspects of gas and heating systems in domestic and light commercial applications
Manufactured to BS EN 1254-1
Min temperature at Max pressure: 30°C at 25 Bar
Max temperature at Max pressure: 110°C at 10 Bar
25 Years Guarantee
Requires solder and blowtorch
Central Heating Supplies
Hive Thermostat Frame£17.96
Hive Active Light™ Dimmable Bulb£19.98
Ring Stick Up Camera 1080P£80.10 – £89.00
Philips Hue White Filament Bluetooth£24.99
Philips Hue White Filament Bluetooth ST72£29.99
Electric Heaters & Dryers
Smart Panel Heater£99.98 – £124.98
Philips Hue White Filament Bluetooth G125£34.99